Download FlashDrive/104 - Connect Tech Inc.

Revision 0.08
Connect Tech FlashDrive/104 User's Manual
Board Overview
Figure 1: FlashDrive/104 Layout
Location
P9
P8
P1
P2
P6, P7
P5
P3
Table 1: FlashDrive/104 Components
Description/Function
Master / Slave Selection and Write Protect
ATA/IDE 0.100” Connector
ATA/IDE 2mm Connector
DDG/ DEG: pins 41 & 42 are connected to 5V
DGG: pins 41 & 42 are not connected
Diagnostic Header (Connect Tech use only)
PC/104 Connector – specifications available from the PC/104 Consortium
PCI-104 Connector -specifications available from the PC/104 Consortium
Power Connector:
Pin
Signal
1
N/C (+12 V on cable)
2
N/C (GND on cable)
3
GND
4
+5V
NOTE: P5, P6 and P7 are used with mechanical stack throughs only. P3 provides power over
standard PC disk drive power connectors (5V only)
2