Download manual pdf

Transcript
User Manual
Chapter 6. Configuration File MANAGEMENT
6.4.
MCMUX.RMP File
6.4.1.
MCMUX.RMP File Parameters
MCMUX.RMP parameters define program re-mapping and packet identifiers (PID). The fields
are summarized in Table 6-2.
The format column refers to the following input format:
•
s- string.
•
n, m, l- numerical.
•
IP- IP address format.
•
status – fixed options.
Table 6-2:
RCMUX.RMP File Parameters
FIELD
FORMAT
DESCRIPTION
RANGE OF VALUES
RemapInPIDSt
nm
Selects the start PID
for automatic
input-PID
re-mapping.
n = input-id (0 - 9).
m = start pid (hex) for the automatic pid
remapping for this channel.
if 0x1fff is used no automatic
remapping is done and the pids are
stay the same.
0 disables the unspecified PIDs.
RemapInPid
nmls
Re-maps a specific
input PID.
n = input-id (0 - 9)
m = specific pid (hex) to remap.
l = pid (hex) to put insted of 'm'.
0 disables the PID (For PMTs).
s = optinal pid type [pcr,pat].
RemapInProgSt
nm
Selects the start
program number for
automatic program
remapping.
n = input-id ( 0 - 9).
m = program number for automaic
program remapping.
if -1 is used no automatic remapping
is done and the prog. numbers are
stay the same.
RemapInProg
nml
Remaps a specific
input program
number.
n = input-id ( 0 - 9).
m = specific program number to remap.
l = program number to use instead of ‘m’
InputsEnaDisArr
n
Enables or Disables
a specific input.
n = sequence of 10 digits, one digit for
each port.
Left most digit is “port 0”,
Right most digit is “port 9”.
Port status is given by the value of the digit:
0 = Port disabled
1 = Port enabled
Page 6-8
P/N 100374