Download manual pdf
Transcript
User Manual Chapter 6. Configuration File MANAGEMENT 6.4. MCMUX.RMP File 6.4.1. MCMUX.RMP File Parameters MCMUX.RMP parameters define program re-mapping and packet identifiers (PID). The fields are summarized in Table 6-2. The format column refers to the following input format: • s- string. • n, m, l- numerical. • IP- IP address format. • status – fixed options. Table 6-2: RCMUX.RMP File Parameters FIELD FORMAT DESCRIPTION RANGE OF VALUES RemapInPIDSt nm Selects the start PID for automatic input-PID re-mapping. n = input-id (0 - 9). m = start pid (hex) for the automatic pid remapping for this channel. if 0x1fff is used no automatic remapping is done and the pids are stay the same. 0 disables the unspecified PIDs. RemapInPid nmls Re-maps a specific input PID. n = input-id (0 - 9) m = specific pid (hex) to remap. l = pid (hex) to put insted of 'm'. 0 disables the PID (For PMTs). s = optinal pid type [pcr,pat]. RemapInProgSt nm Selects the start program number for automatic program remapping. n = input-id ( 0 - 9). m = program number for automaic program remapping. if -1 is used no automatic remapping is done and the prog. numbers are stay the same. RemapInProg nml Remaps a specific input program number. n = input-id ( 0 - 9). m = specific program number to remap. l = program number to use instead of ‘m’ InputsEnaDisArr n Enables or Disables a specific input. n = sequence of 10 digits, one digit for each port. Left most digit is “port 0”, Right most digit is “port 9”. Port status is given by the value of the digit: 0 = Port disabled 1 = Port enabled Page 6-8 P/N 100374