Download AFE Controller User`s Manual
Transcript
Operating Modes CASE A: One Single Phase Controller AC Line A LOAD AC Line B 21 12 21 J1 J4 J2 CASE C: Three Single Phase Controllers 1 Fast Inhibit 12 Soft Inhibit 13 16 17 J21 0-10V Command OZSCR1x00 AC Line A #1 LOAD 11 7 18 J23 #2 21 LOAD Bias Supply Input (AC: OZSCR1000) (DC: OZSCR1100) CASE B: Two Single Phase Controllers #3 LOAD AC Line B AC Line A #1 LOAD #2 LOAD 12 21 12 J4 J2 J5 Fast Inhibit 12 13 Soft Inhibit #2 14 0-10V Command #1 0-10V Command #2 16 17 11 J21 7 18 8 19 12 21 12 J5 J3 J6 1 Soft Inhibit #1 13 Soft Inhibit #2 14 Soft Inhibit #3 15 16 17 11 J21 7 18 0-10V Command #2 8 19 0-10V Command #3 9 20 1 Soft Inhibit #1 21 J2 12 0-10V Command #1 21 12 J4 Fast Inhibit AC Line B J1 21 J1 OZSCR1x00 J23 21 OZSCR1x00 Bias Supply Input (AC: OZSCR1000) (DC: OZSCR1100) J23 21 Bias Supply Input (AC: OZSCR1000) (DC: OZSCR1100) Figure 15 - Typical Single Phase Controller Applications 3.1.5 Phase Control Configuration Options Either an analog input or the Control Setpoint register (0x0003) can be used to set the conduction angle, , as determined by the Phase Angle Control Mode register (0x1020). Figure 16 provides a block diagram of Phase Angle Control Mode. Publication UM-0040 21