Download Start up Guide - TSM Control Systems

Start up Guide
Ensure that the load cell
bracket is not touching the
guards on the slide valves
Ensure that the air is taken off the blender before doing the weight calibration.
 Touch
 A keypad will pop up.
 Enter the supervisor password then return
(Factory default password is set to 5)
1.2.1 Taring the weight to zero
Ensure that the mixing chamber door is open
and the weigh hopper is empty and there is
nothing touching the weigh hopper before
taring the load cell.
Press
to set the weight to zero.
1.2.2 Weight Calibration.
Gently slide the weigh hopper out and place a
known weight into it (use a weight close to
the batch size
PLC Start up Rev 1.1
Page 3