Download to the user guide

GasAlertMicroClip XT
Calibration
When a sufficient amount of gas has been detected (approximately 30 seconds after the gas has been applied), the detector
beeps once,
flashes, and K remains lit while the detector completes the span (approximately 2 minutes).
Successful Span
If the sensors have spanned successfully, the detector beeps and the
calibration procedure continues.
Unsuccessful Span
If any sensors fail the span, the following screen displays. Refer to
Calibration Troubleshooting.
Calibration Due Date
Note
If a sensor fails calibration, the next due date for that sensor
will not reset. Refer to Calibration Troubleshooting.
43