Download "user manual"

Transcript
User Manuai Delft- 1 D2D Q2755
November, 2000
The output for GIS systems, like ARC View, is one of the three types of 2D-specific output
available. In this screen, you can select if you want this output to be generated or not, and for
which timesteps. 1f any (combination) of the available variables is selected here, SOBEK will
automatically create '.ASC' output files which can be imported into a GIS based program.
There are sorne additional rules to remember, which will be explained further on.
The GIS output data is written to a number of different files. The first type consists of output
files in .asc format (see appendix A). SOBEK creates these output files only when the switch
'create ASCII-output for water depth, water level and velocity' is switched on! One of these
is generated for every selected output timestep and for every selected variable. In general, It
is a good idea to wait with generating this output (if you need it at all, of course) until you
are pretty sure that the simulation is going to give you the results that you need. Suppose
your simulation lasts 24 hours, and you want GIS output for every timestep (of, for example,
one minute) and for all five variables, you would get 5x24x60 equals 7200 output files!
Warning: Right now, SOBEK can handle only a certain maximum number of files in the
case directory. 1f you decide to switch on the 'ASCII-Output Option', you might actually
reach this maximum number of files (because of all the .asc files generated), which means
that you might not be able to save your case properly! In that case you will get the message
with saving your case: "too many files in case directorv; Check the configuration of the
application; erase unregistered files". In this case you should reconsider you output choices
to decrease the number of output files.
The second type of output files is the binary 'map file. For every variable chosen, a file is
produced. It contains the values of that variable for every timestep and every grid element of
one particular grid. In resuits in maps, the user can select these map files and produce .asc
files out of them. So actually, the map file contains the same information as the .asc files
described earlier, but in a compressed format. Please note that whether MAP files are written
or not, only depends on the Output Parameters chosen in the GIS Outpul Options tab, and
not on the ASCII-Oulput option switch!
The last type of GIS output files are 'special' .asc files. These files contain the following
variables:
(d_max)
•maximum water depth
(tdmax)
•time of maximum water depth
(h_max)
•maximum water level
(thmax)
•time of maximum water level
(v_max)
•maximum velocity
(t_vmax)
•time of maximum velocity
(t_wet)
•time of wetting
•time of wetting per class ('permanentie')(twet/class)
(tdry)
•time of drying
•time of drying per class ('permanentie') (tdry/class)
(dd/dt)
•rate of change of water depth
WL
1
delft hydraulics 3-6