1
Download PX Developer Version 1 Operating Manual (Monitor Tool)
Transcript
10 FACEPLATE MELSOFT These items in the following table are the example items of "Section 10.3 Displaying Parts on Faceplate" displayed in the faceplate of each tag type. As for the display contents and operations of the corresponding item in the following explanations of each faceplate display, refer to sections in "Reference". Part Reference Loop Tag type Status Alarm Message PID 2PID 2PIDH PIDP SPI IPD BPI R ONF2 ONF3 PFC_SF PFC_SS PFC_INT PGS PGS2 MOUT MONI SWM MWM SEL BC PSUM PVAL HTCL NREV REV MVAL1 MVAL2 PB TIMER1 TIMER2 COUNT1 COUNT2 ALM ALM_64PT MSG MSG_64PT I/O Control Motion STC Time in the step Mode mode type setting setting Section Section Section Section Section 10.3.2 10.3.3 10.3.4 10.3.5 10.3.6 ------------------------------------------------------------------------------------------------------------------------------------- ---------- ---------------------------- ------- ------------------------- ------------------------------------------------------------------- ------------------------------------------------------------------- ------------------------------------------------------------------- PV value setting Section 10.3.7 SV value setting Section 10.3.8 MV value setting Section 10.3.9 ( ) ( ) ( ) ---( ) ---- ( ) ( ) ( ) ------------------( ( ( ( ) ) ) ) ------------- ---------------------- ---------------------------------------- ------- ------------------------------------------------- BC C/T STATUS Count setting opera- opera- operation tion tion Section Section Section Section 10.3.10 10.3.11 10.3.12 10.3.13 ------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- : Display corresponding to faceplate, ( ): Only display a part of common pattern, Command button operation Section 10.3.14 ------------------------------------------------------------------------------------------------------------- : No display REMARK In SV value of R, bar is display by ratio to PV value. In MV value setting of ONF2 and ONF3, bar is not displayed and the MV value setting button can only be set as 2 position (0%, 100%) or 3 position (0%, 50%, 100%) In SV value setting of PGS, bar is not displayed, display SV pointer on the Section 10.3.1). pattern graph ( 10-32 10-32
