Download User`s Manual

Transcript
BroadLighter-D Series User Manual
predetermined nominal current value during the time of 0.1 sec,
allowing the current to be slowly sourced to an SLD module. With this
feature in use, an overdamped switch-on response of the driver without
any overshooting over the nominal current setting is guaranteed.
Moreover, the time of 0.1 sec is long enough to eliminate a sharp
temperature-related current impact on the TEC at start-up; therefore
high reliability for the TEC operation throughout its lifetime is ensured.
Another benefit of the 0.1-sec start-up time is that all turn-on transients
in the driving current completely die out during this time before
applying the current to an SLD, thereby not affecting the SLD
operation. (It is important to note that, in most cases, applying these
transients to an SLD leads to either its catastrophic destruction or
parametric degradation of its performance.)

Clamping limit circuit for SLD current —This circuit provides a
clamping limit for the SLD driving current so that an SLD is effectively
prevented from overdrive by an excessive current above the limit point
(commonly called "limiting threshold"). To help the user identify the
situation in which the driving current has reached the limiting threshold,
a LED indicator called "Service" has been added on the front panel of
the BroadLighter. Once the current has reached the limiting threshold,
the LED lights up, thereby showing the user that the current is being
limited.

Automatic power control (APC) for SLD operation—This feature
makes it possible to maintain the optical output power of an SLD
module at a constant level by automatically increasing or decreasing the
SLD driving current. To do this, a feedback loop with a photodiode
monitor built into the SLD module is used. The function of the loop is
to provide constant feedback on the photodiode current (which in turn is
proportional to the output power of the SLD module) to the current
driver for allowing the driver to change the current flowing through the
SLD in the proper way.

Emergency switch-off for SLD module—When there is any risk for an
SLD module to be operated improperly (for example, the active
temperature control for the SLD module has stopped to maintain the
-16-