Download 1.0 Overview

3.4 Selecting the correct Target Device
It is important to select the correct ‘Target Device’ when programming a 'Z-WAVE 500 series'
device. The part number of the device should be printed on the top of the chip e.g. ‘SD3502’.
3.4.1 Device selection


Click <Next>  the <Select Target Device> screen will be displayed.
Type in the ‘Device Part Number’ e.g. ‘SD3502’ into the ‘Search for Device’ field
 a list of all matching devices will be displayed in the box underneath.

As the Z-wave 500 series devices can be programmed via different 'programming interfaces',
the device list shows the available interfaces eg. SPI or UART interfaces for the SD3502
device.
 Select the required device / programming interface from the list e.g. ‘SD3502 (SPI)’ and then
click <OK>
 The SD3502 device is now selected and will be programmed via the 'SPI' interface..
AN145- In-System Programming (ISP) of Sigma Z-Wave 500 series SOC devices and modules
21