1
Download PMCprimo C Programming Manual
Transcript
4 Status and error messages 4.2 Error messages Code Error 264 Reserved for soft PLC 265 Reserved for soft PLC 266 Reserved for soft PLC 267 Reserved for soft PLC 268 Reserved for soft PLC 269 Reserved for soft PLC 270 Reserved for soft PLC 271 Reserved for soft PLC 272 Reserved for soft PLC 273 PD command not possible! Incorrect PMCtendo DD4 version (< 4.94) 274 Node <...>, drive command incomplete! 275 Message from soft PLC: CAN device is not a DD4 276 SoftSPS is using battery-buffered memory. 277 The maximum possible position (SB*SM) exceeds the value range of %ld (<%c%c> command) 278 Cannot modify the pre-defined position table 'LIN‘AR'. 279 The interpolator for the CNC application is active, so cannot execute the %c<%c%c> command. 280 Note: The ZC command has no function on absolute encoders! 281 Error: Number of Ethercat systems has changed! Axes will be stopped 282 CAN error: %s 283 “ML” must be executed before “XI” 284 XI command: Master position was not found 285 Slave value does not exist in the position table 286 Output is reserved for PLC 287 Cannot execute PC command because the controller is not ready for operation 288 Module on slot %ld of node %ld may not be moved up 289 Module or module configuration on slot %ld of node %ld is not supported 290 Node no. %ld: Too many digital input modules used or more than 4 TPDOs required 291 Node no. %ld: Too many digital output modules used or more than 4 RPDOs required 292 Node no. %ld: Too many analogue input modules used, 8 analogue inputs are supported Pilz GmbH & Co. KG, Felix-Wankel-Str. 2, 73760 Ostfildern, Germany Telephone +49 711 3409-0, Telefax +49 711 3409-133, E-Mail: [email protected] 4-239
