Download 4 - Downloads

User’s Manual 1.0.2
2. Precautions
The following conventions are used to indicate precautions in this manual.
could result in injury or damage to property.
！
Warning
！
Caution
Failure to observe precautions
Failure to observe these instructions could result in death or bodily injury of the
operator.
Failure to observe these instructions could result in physical damage to
equipment.
2.1.Safety Precautions
Please read carefully the following safety precautions to assure correct use of the JTAG-Blazer.
！
Warning
This product uses semiconductor components designed for generic electronics
equipment such as office automation equipment, communications equipment,
measurement equipment and machine tools. Do not incorporate the product into
devices such as medical equipment, traffic control systems, combustion control
systems, safety equipment and so on which can directly threaten human life or pose
a hazard to the human body or property due to a malfunction or failure. Moreover,
products incorporating semiconductor components can be caused to malfunction or
fail due to foreign noise or a surge. To avoid injury, death or loss of property in the
case of malfunction or failure, be sure to take all possible safety measures.
2.2. Handling Precautions
To avoid degradation, damage, malfunction, fire or electric shock, the following precautions must be
observed when handling this product.
Handling the main unit
！
Warning
・ Guard against excessive shock to the unit caused by stepping, dropping or
tapping the product. Failure to do so could result in damage, fire or electric
shock.
・ Do not operate the unit with wet hands. Failure to observe this could result in
malfunction, fire or electric shock.
・ Do not spill liquids such as water on the unit. Failure to observe this could result
in malfunction, fire or electric shock.
・ Should water be spilled on the unit, turn off the power switch, remove the AC
adapter from the outlet and then contact a local distributor.
・Do not disassemble or modify the unit.
・ Do not operate the unit in a manner other than specified in this document.
Failure to observe this could result in an accident or malfunction.
・ Be sure to use the supplied AC adapter to power the unit.
・Turn on the unit’s power switch before turning on the target board.
・Store and operate the unit in a stable place.
・Operate the unit at a room temperature of 0 to 40 degrees C.
・ Do not operate the unit in excessively moist or dusty environments or where there
is a possibility of water leaks. Failure to observe this could result in malfunction,
fire or electric shock.
2