Download V5VB5 manual

V5 series inverter
Fig. 3-7 Setting the parameters in running status
1)State parameter can only display seven parameters from b-00 to b-06
with factory setting, you can view other status parameters by
changeing P3.41 and P3.42.
(2) When you want to view status monitor parameter, press
can
shift to default monitor parameter display status.The default monitor
parameter in stopping states is setting frequency and in running states
is output frequency.
2. Function parameter
Take the following as an example: reset function parameter P3.065 from
5.00Hz to 8.50Hz.
Fig. 3-8 Parameter editing
In three level menu states, the parameter can’t be changed if none digit
of the parameter is flashing, the possible reasons are:
(1) The setting of this parameter can not be changed, such as the actural
detected parameters or recorded parameters.
(2) This parameters can only be changed in stopping state and can not be
67