Download Manual HRUC-E

Transcript
5.3.2
Fan error
This scheme is intended
only for the installer.
Extract or supply fan stopped
Maintenance by the end user is
not only dangerous but also has
a negative effect on the
warranty.
Pull the plug out of
the socket
Open the front lid of
the unit
Put the plug back in
the socket
Are both fans turning?
Yes
No
Open the cover of
the control board
No
Ja
Measure (within 1
minute after putting the
plug back in) if there is a
voltage between 0 and
10 volts on the poles 0
and U1 or U2 as shown
in section 6.5. Is the
voltage correct?
Measure (within 1
minute after putting the
plug back in) if there is a
voltage of 230V on the
poles K1 (see scheme
section 6.3). Is the
voltage correct?
No
No
Pull the plug out of the socket, replace the
cables of the fans and put the plug back in
the socket
Pull the plug out of
the socket
Pull the plug out of
the socket
If this does not work or when
this is not possible, replace the
complete fan set and put the
plug back in the socket
Replace the
control board and
put the plug back
in the socket
Replace the
control board and
put the plug back
in the socket
19