Download Modicon M168 Controllers Network Connectivity
Transcript
Troubleshooting and Diagnostics Slow Segments Symptom A segment with 2 or more routers connected to it is very slow. A sniffer shows continuous Who-Is and I-Am broadcast traffic. Solutions S1A3839300 12/2012 Diagnosis Action circular routes Check for circular routes. Often, 2 routers are mistakenly connected to the same Ethernet segment, both of which have Ethernet 8802-3 and BACnet/IP ports. Only one of the routers can have routing to both ports enabled. (The other router must disable routing to one of the ports.) Otherwise a circular route is created, even if the network numbers are different. Look at the HopCount in sniffer traces of routed Who-Is messages. The HopCount starts at 255 and is decremented each time the message is routed to another segment. Typical networks only have 2 or 3 levels, so HopCounts of less than 252 indicate that the message is circulating more than once through routers. broadcast storms Check for broadcast storms. It is possible to send Who-Is messages without a qualifying range of device instance numbers, but the broadcast of unqualified Who-Is messages globally can create a large amount of responding I-Am traffic. Such traffic can overwhelm routers and BACnet MS/TP networks. Use the sniffer to look for a Who-Is message that does not have a range qualification to find the sending device. 173