Download Modicon M168 Controllers Network Connectivity

Transcript
Troubleshooting and Diagnostics
Slow Segments
Symptom
A segment with 2 or more routers connected to it is very slow. A sniffer shows
continuous Who-Is and I-Am broadcast traffic.
Solutions
S1A3839300 12/2012
Diagnosis
Action
circular routes
Check for circular routes. Often, 2 routers are mistakenly connected to the
same Ethernet segment, both of which have Ethernet 8802-3 and
BACnet/IP ports. Only one of the routers can have routing to both ports
enabled. (The other router must disable routing to one of the ports.)
Otherwise a circular route is created, even if the network numbers are
different. Look at the HopCount in sniffer traces of routed Who-Is
messages. The HopCount starts at 255 and is decremented each time the
message is routed to another segment. Typical networks only have 2 or 3
levels, so HopCounts of less than 252 indicate that the message is
circulating more than once through routers.
broadcast
storms
Check for broadcast storms. It is possible to send Who-Is messages
without a qualifying range of device instance numbers, but the broadcast of
unqualified Who-Is messages globally can create a large amount of
responding I-Am traffic. Such traffic can overwhelm routers and BACnet
MS/TP networks. Use the sniffer to look for a Who-Is message that does
not have a range qualification to find the sending device.
173