Download Modicon M168 Controllers Network Connectivity

Installation
NOTICE
ELECTROSTATIC DISCHARGE
z
z
Use measures in accordance with IEC 61340-5-2 when handling the module or
the controller.
Do not touch any internal components.
Failure to follow these instructions can result in equipment damage.
Verify that the order number on the nameplate of the module corresponds to the
module that you want to install.
Plugging a Module into the Controller Slot
Mount your module in the Modicon M168 controller.
Step
Action
1
Remove the plastic cover from the network connectivity slot, shown in the top right:
2
Slide the module into the top right slot of the Modicon M168 controller:
NOTE: The module lever clicks when the module is properly seated in the controller.
3
Make these connections:
z For BACnet MS/TP networks, attach the included mating connector to the
module.
z For BACnet/IP or Modbus TCP networks, no mating connector is needed. Use a
regular Ethernet cable that is terminated with an RJ45 connector.
4
Apply power to the Modicon M168 controller.
NOTE: After the module is mounted, connect the cables. When this is done,
commission the modules (see page 67) to complete the installation process.
46
S1A3839300 12/2012