Download Feed-forward Control System for Fed
Transcript
5 Conclusion and Recommendations Even though the same total amount of nutrient solution was fed to the bioreactors in each of the three experiments (feedback, manual feed-forward and BioXpert feed-forward), each set performed quite differently. Reason of this result was the different feeding strategies that were used. In the previous feedback experiments, sampling was carried out every two hours and feeding performed differently for each shot. For the manual feed-forward experiments, one single daily feed was performed. Finally, for the BioXpert feed-forward experiments, the solution was fed every 8 hours (3 times daily). The results presented in section 4 and Appendix 1 of the report are not conclusive since there are no replicates to demonstrate reproducibility. Assuming that the results are accurate, Feed-forward control mechanism was successfully implemented by using feed profiles generated from previous feedback experiments. Feed-forward control was applied on the nutrient feed by BioXpert, a SCADA system software. The viable cell density results obtained from the BioXpert feed-forward experiments were comparable to manual feed-forward experiments but both were lower than the feedback experiments. Since both of the feed-forward experiments yielded similarly low cell density results, it can be concluded that feedback control had a positive effect on the growth of CHO cells. The feedback and BioXpert feed-forward experiments generated similar amounts of monoclonal antibody; whereas manual feed-forward experiment produced lower values. Therefore, it may be determined that BioXpert algorithm had a positive effect on the protein production and helped the feed-forward control strategy to produce improved titer results. Levels of pH, partial pressure of CO2, glucose, lactate and osmolality were kept at desired values (refer to Appendix A for data). Partial pressure of O2 was mistakenly kept at high values of 78 to 121 mmHg (refer to Appendix A for data). Since there were no previous experiments performed at high pO2 levels, the effect of high range cannot be determined. 25