Download Operator`s Manual
Transcript
Operation Once logging has started, you may exit the Log/Status dialog box, and turn off the Pocket PC to conserve battery power. The DataLogger® will continue to log data while you monitor and control the fusion process – heat, soak, fuse cycles. PH02949-3-14-04 Logging the Fusion Process (cont'd) At the end of the fusion process, you may stop logging by holding the DataLogger® switch for 4 seconds. The DataLogger® will stop logging and stop flashing its red LED. The LED will now flash green to indicate normal operation. Alternatively, you may also stop logging from your Pocket PC. If the Pocket PC was turned off, turn it on. In the Log/Status dialog box tap Connect. Once connected, the current status of the DataLogger® is displayed: Tap Stop at the end of the fusion process. (Always make sure to stop logging before opening carriage to remove pipe) PH02950-3-14-05 Note: always stop logging before opening carriage to remove pipe. Otherwise, it will introduce an unintended change in pressure at the end of the joint report graph. The Pocket PC begins to request joint report data from the DataLogger® a block at a time until it is all downloaded. 5 - 11 PH02952-3-14-05 PH02951-3-14-04 A confirmation message box appears. Tap Yes to stop logging.