Download DL-32 Multi-sensor Universal Data Logger User Manual
Transcript
Select if you use a drive-shaft sensor or a wheel sensor. Enter the pulses per rotation created by the sensor either as driveshaft rotation or wheel rotation. You also need to enter the wheel diameter, and in case of a drive-shaft sensor, the final drive (differential) ratio. The LM-Programmer will calculate the pulses per mile (km) for you. This functionality is also available for Inputs 4 and 5. 13.6 Input 4 configuration Function 1,2,3 and 4 on this input are used for pressure measurement. See chapter 7 for details. For Custom Frequency, Custom RPM, speed sensing and duty cycle inputs on Input 4, see chapter 12.5 13.7 Input 5 Configuration For Custom Frequency, Custom RPM, speed sensing and duty cycle inputs on Input 5, see chapter 12.5 When selecting one of the acceleration measurement modes for Input 5, the center of the window changes to this: Select the travel direction of the car. Please note that changing this setting will effect the travel direction setting for side force measurements on Input 2 as well. - 27 -