Download Manual - Equipco

To charge the PHA-100Plus
•
•
•
•
•
Remove the interface adapter from the kit.
Open the cap covering the socket on the back of the meter.
Line up the red dots on the connector with the socket and insert
the connector until it latches.
Plug the charger unit into an AC outlet and attach it to the
interface cable.
Twelve to fourteen hours are needed to charge the PHA-100Plus.
The unit may be run on AC power during calibration or setup.
To prevent “Battery Memory,” fully discharge the PHA-100Plus once a
month before recharging the battery. To discharge the battery, turn ON
the backlight, and leave the PHA-100Plus ON until the display turns OFF.
The battery of an automobile can also charge the PHA-100Plus. The kit
includes an adapter that plugs into a car’s cigarette lighter. This plugs into
the interface adapter.
As a rule of thumb, the operating time of the battery will be approximately
the same as the amount of time which the instrument was charged, provided
the backlighting option on the display is not selected.
992041, Release 1.3
February 4, 2005
4