Download User`s Manual

EXTERNAL CONTROL
EXTERNAL CONTROL
The rear panel has an analog programming
connector, a TRIG IN BNC terminal, a TRIG OUT
BNC terminal and a VOLT TRIG BNC terminal.
The Analog Programming Terminal is used for
external voltage, current and resistance control of
current and voltage output. The trigger BNC
terminals are used for trigger input and output
signals.
Analog Control ............................................................... 144
Analog Programming Connector Overview ...................................................... 144
External Voltage Control of Voltage Output .................................................... 147
External Voltage Control of Current Output .................................................... 149
External Resistance Control of Voltage Output................................................ 150
External Resistance Control of Current Output ............................................... 152
External Control of Output ................................................................................. 155
External Control of Shutdown ............................................................................ 157
External Alarm Clear ............................................................................................. 159
Remote Monitoring ........................................................ 161
External Voltage and Current Monitoring ......................................................... 161
External Operation and Status Monitoring ........................................................ 163
143