Download PowerHome QuickStart Guide

Transcript
Turning On A Light
3.1
But, How Do I Turn On A Light?
If you’re like most PowerHome users, you’ve already thought about the many things you want to
do with PowerHome. PowerHome can control not only home lighting (X-10 and Insteon) but
home theaters (through IR and RS232, X-10 and Insteon), blinds and drapes, heating and air
conditioning systems, security systems (Elk M1 Gold), sprinklers, make voice announcements,
get the weather through the Web and announce it or show it on your PC, touch screen or web
enabled phone, announce telephone callers (Caller ID with an appropriate modem) and the list
goes on. PowerHome can control your home not only through your PC, but through remote PCs
throughout your home, touch screens, through the web and email. It can email you home status
reports, alerts or whatever you choose. This list is not exhaustive. Imaginative PowerHome
users have implemented many additional uses for PowerHome.. An active PowerHome user
forum, where PowerHome users share ideas, can be found at http://www.powerhome.com/forum/default.asp.
The first thing most new PowerHome users want to know is how to turn on a light. This part of
the QuickStart guide will take you through the basic steps to turn an Insteon light switch on and
off. The rest of the QuickStart guide will take you on a brief tour of some of PowerHome’s
features. Additional instructions and features can be found in the PowerHome Users Manual.
3.2







Checklist For Turning On An Insteon Light
Install PowerHome (see section 2 above)
Let PowerHome know you have an Insteon PowerLinc Controller (see section 3.3)
Let PowerHome know you have an Insteon light switch (see section 3.4)
Turn on the light using the Device Status Screen (see section 3.5)
Or Turn on the light using the Insteon Explorer Screen (see section 3.6)
Or Turn on the light using a macro (see section 3.7)
Or Turn on the light using a timed event (see section 3.8)
3.3 Let PowerHome Know You Have An Insteon PowerLinc
Controller
PowerHome interfaces with your home through a variety of hardware controllers connected to
your PC. The various controllers supported by PowerHome are capable of sending and receiving
Insteon and X-10 signals (powerline and RF), IR (infrared) signals, digital inputs / outputs, and
analog inputs / outputs. You should have at least one controller connected to PowerHome, but
you can have multiple controllers connected to PowerHome through your PC.
To set PowerHome up for Insteon use, you must first let PowerHome know that you have an
Insteon controller connected to your PC. You do this through the PowerHome Explorer.
If you have not already done so, start PowerHome on your computer.
10