Download CS5 User Manual

Section 5: CS5 VU Voting/Chairperson Station
5.3 Setting Up
5.3.1 Making Connections
Fig.5 on
Page 29



Screw the microphone capsule on the gooseneck.
Screw the gooseneck into the microphone input (2).
Use the appropriate CS5 MK... cables to connect the system ports on the
microphone station to the system ports on the preceding and subsequent
microphone stations.
5.3.2 Selecting Operating Modes
Important:
• To avoid malfunctioning, do not change any dip switch settings on the Base Unit or
any microphone station while power to the system is ON!
Dip switches
S1, S2
Function
Match microphone station audio input to
microphone output signal.
S3
Unuse
d
S4
Microphone muting on priority request:
S5
Test mode:
S6
S7
S8
Configuration:
Voting from delegate station:
Voting Station operating mode:
Switch positions
0
Microphone can be muted.
1
Microphone will not be muted.
Normal operating
mode as selected
on S8
Last user-selected
configuration
Test mode: Display
indicates data
communication
status.
Factory
default configuration
Enabled
DELEGATE
Disabled
PRESIDENT
Table 3: CS5 VU dip switches.
1. Referring to Table 3 above, set S1 and S2 for the microphone capsule you are
going to connect to the microphone station.
The settings of S1-S2 determine the gain of the audio section as well as the
amount of gain reduction that is applied to the loudspeaker amplifier as soon as
the microphone opens. Therefore, microphone stations with unidirectional
microphone capsules allow delegates to hear other talkers on the built-in
loudspeakers even while the microphone is open.
Important:
• To avoid feedback problems, make sure to set S1 and S2 to the correct positions as
per Table 3 above.
CS5 User Manual
Page 31