Download FPGA in Data Acquisition Using cRIO and LabVIEW: User Manual
Transcript
Figure 10 - Analog Line Output.vi – Running 4. Connect external wires to pins 0 and 1 of the D-subconnector (Figure 11). 5. Connect a multimeter to the wires at set up to read frequency. 6. Under phase increment (Figure 10), enter 1073743 corresponding to 10 kHz. This is what should be displayed on the multimeter. 7. Now enter 1288490 in phase increment. The multimeter should now display 12 kHz. This shows that we can control the NI 9263 through our VI, and concludes this example. 12