1
Download EnRoute 5 - EnRoute Software
Transcript
5. Select the contours and add a 2D Engrave toolpath to the contours. In this example a 1- inch Ball End Tool was used. Make sure that the Follow contour parameter is checked. 6. This is a simulated view of the toolpaths using a 1- inch Ball End tool. A Routing Offset toolpath was applied to the outline contour to cut out the panel. 7. This image shows the same contours but this time a 120degree Conic tool was used. You can see that the shape and size of the tool can make the texture results very different. Texture Tools Page 321
