Download User Manual - Oracle Documentation

MARKUPS
2D-SPECIFIC MARKUPS
Calibrating Distance
Calibrate the distance measurement.
TASK
1.
Measure distance between two points or measure cumulative distance.
2.
From the Distance tab, click Calibrate.
STEP RESULT: The Distance Calibration dialog appears displaying the measured distance
3.
From the Units list, select the unit to which you want to calibrate the distance.
4.
Select Calibrate to and enter a value if you want to calibrate the distance to a
value.
5.
Select Set Factor and enter a value if you want to calibrate the distance by a factor.
6.
Click OK.
STEP RESULT: The calibration result appears in the Measurement dialog.
7.
Click Close to close the Distance tab.
Measuring Area
Use the Area option to measure the area and perimeter of a region.
TASK
1.
From the Markup menu, select Add entity, select Measurement, and then select
Area.
ADDITIONAL INFORMATION: From the Markup Entity toolbar, you can also click Area
.
STEP RESULT: The Measurement Entities dialog appears.
2.
From the Measured Area Units list, select the unit in which you want to measure
the area.
3.
From the Perimeter Units list, select the unit in which you want to measure the
perimeter.
4.
To cumulate a Net Area Result of different areas, select Add.
5.
To subtract an area from the Net Area Result, select Subtract.
6.
Select Clear to clear the Net Area Result field.
7.
Click a point on the drawing to define the starting point.
8.
Continue clicking points on the drawing to define the area you want to measure.
STEP RESULT: Each point is joined by a line.
224