Download Excel 10 - CentraLine
Transcript
EXCEL 10 HYDRONIC CONTROLLER SYSTEM ENGINEERING Equipment Control The available options for equipment control configurations with the default values shown are listed in the following table. See Configurations section above for more information on parameters. Table 15. Hydronic Controller equipment control configuration options. Function Configuration options Default 1 Output 1 valve direction direct reverse direct Output 2 valve direction1 direct reverse direct Output 1 minimum stage off time 0 to 600 seconds 90 s Output 2 minimum stage off time 0 to 600 seconds 90 s Output 1 valve run time/PWM period/minimum stage on time floating/floating-mid - valve run time (20 to 600 seconds) PWM - cycle time (20 to 600 seconds) 1, 2, and 3-stage - minimum on time (0 to 1200 seconds) 150 s Output 2 valve run time/PWM period/minimum stage on time floating/floating-mid - valve run time (20 to 600 seconds) PWM - cycle time (20 to 600 seconds) 1, 2, and 3-stage - minimum on time (0 to 1200 seconds) 150 s PWM zero position2 0 to 100% 0% 2 PWM full position 0 to 100% NOTES: 1. Valve action settings apply to floating, PWM, or thermal types. 2. Settings apply to both actuators if both are PWM. 100% Switching Levels The available options for switching level configurations with the default values shown are listed in the following table. See Configurations section above for more information on parameters. Table 16. Hydronic Controller switching levels configuration options. Function Configuration options Default Cooling stage 1 switching level 0 to 100% 5% Heating stage 1 switching level 0 to 100% 5% Cooling stage 2 switching level 0 to 100% 50% Heating stage 2 switching level 0 to 100% 50% Cooling stage 3 switching level 0 to 100% 75% Heating stage 3 switching level 0 to 100% 75% Cooling hysteresis 0 to 100%, 10% Heating hysteresis 0 to 100% 10% 27 74-2935-3r0909