Download Excel 10 - CentraLine

Transcript
EXCEL 10 HYDRONIC CONTROLLER SYSTEM ENGINEERING
Equipment Control
The available options for equipment control configurations with the default values shown are listed in the following table. See
Configurations section above for more information on parameters.
Table 15. Hydronic Controller equipment control configuration options.
Function
Configuration options
Default
1
Output 1 valve direction
direct
reverse
direct
Output 2 valve direction1
direct
reverse
direct
Output 1 minimum stage off time
0 to 600 seconds
90 s
Output 2 minimum stage off time
0 to 600 seconds
90 s
Output 1 valve run time/PWM
period/minimum stage on time
floating/floating-mid - valve run time (20 to 600 seconds)
PWM - cycle time (20 to 600 seconds)
1, 2, and 3-stage - minimum on time (0 to 1200 seconds)
150 s
Output 2 valve run time/PWM
period/minimum stage on time
floating/floating-mid - valve run time (20 to 600 seconds)
PWM - cycle time (20 to 600 seconds)
1, 2, and 3-stage - minimum on time (0 to 1200 seconds)
150 s
PWM zero position2
0 to 100%
0%
2
PWM full position
0 to 100%
NOTES:
1. Valve action settings apply to floating, PWM, or thermal types.
2. Settings apply to both actuators if both are PWM.
100%
Switching Levels
The available options for switching level configurations with the default values shown are listed in the following table. See
Configurations section above for more information on parameters.
Table 16. Hydronic Controller switching levels configuration options.
Function
Configuration options
Default
Cooling stage 1 switching level
0 to 100%
5%
Heating stage 1 switching level
0 to 100%
5%
Cooling stage 2 switching level
0 to 100%
50%
Heating stage 2 switching level
0 to 100%
50%
Cooling stage 3 switching level
0 to 100%
75%
Heating stage 3 switching level
0 to 100%
75%
Cooling hysteresis
0 to 100%,
10%
Heating hysteresis
0 to 100%
10%
27
74-2935-3r0909