Download TELOS Nx6/Nx12 - Media

| 25
3
Basic Configuration
3.1 Step-by-Step
Here is a step-by-step guide to basic Talkshow System configuration for a new installation:
♦♦ Enter TCP/IP
addresses, if used, for Web interface, remote control, and Livewire audio
networking. See Section 5.3.
♦♦ Set
Input Source for Analog, AES3, or Livewire. See Section 5.8 if you will be using
Livewire.
♦♦ If
you are using Livewire, configure it using the Web interface.
♦♦ Connect
your mixing console mix-minus(es) to the Talkshow System inputs, and the
Talkshow System outputs to console inputs.
♦♦ If
you have analog Telco lines, configure for your region. See Sections 3.3 and 5.5.
♦♦ If
you have ISDN Telco service,
♦♦ Are
you familiar with ISDN? If not, read Section 2.2.
♦♦ Configure
ISDN. See Section 3.4.
♦♦ Confirm
ISDN is working.
♦♦ Read-up
on Desktop Director Operation. See Section 4.
♦♦ Configure
♦♦ If
the various audio options for processing, etc. See Section 5.4.
you will split the Talkshow System between two studios, see Section 5.7.
You may use either the Web interface or the front panel LCD/button interface for most configuration operations. The Web may be more convenient since you have a PC’s rich interface at
your service and you can work by remote.
Some configuration can only be done by Web, such as setting ISDN Directory Numbers and
SPIDs and making Livewire channel assignments. See Section 5.3 for detailed information on
using these interfaces.
3.2 Configuration for Telephone Lines
The Talkshow System has two Telco interface positions, designated A and B. The Nx6 will only
have slot A populated. Slot B can be populated if you choose to convert the Nx6 to a Nx12.
The Nx12 will, of course, have both slots populated. There are three module types and you can
determine which you have by noting the connectors: