Download NION Dante Hardware Manual

Chapter 5 - Setting up the NION
.
Configuration steps
Once you have physically installed and connected the NION (as described in Installing the
NION), follow the procedures below to configure it with the most important settings.
If the NION has a front panel, you can use this to specify the settings. If the NION is not fitted
with a front panel (it is a NION nE), you will need to connect to it using the IP address printed
on a sticker on the rear of the unit.
 To configure a NION with a front panel
1. Specify a name for the NION (on page 26).
2. Specify an IP address for the control network (on page 26).
3. Check that the interfaces you want to use are enabled (on page 29).
4. Open a web browser, connect to the NION on the control network, then set the time and
date (on page 37).
 To configure a NION without a front panel
1. Open a web browser, connect to the NION using its IP address, then configure the network
settings (on page 33).
2. Specify a name for the NION (on page 35).
3. Check that the interfaces you want to use are enabled.
4. Set the time and date (on page 37).
24
Version 1.7.2.0
March 27, 2015