Download Modular POS-Printer User Manual Edition

Transcript
CHANGING THE RIBBON CASSETTE
Changing the ribbon cassette
Switch off the printer. Press the release button at the right hand side of the
front and lift up the housing cover. Then lift up the flap. Now you will see the
ribbon cassette and the print head.
Caution! The print head may be hot! Allow the print head to cool before
touching it.
Remove the used ribbon cassette. Take hold of the handle bar and
withdraw the cassette.
Be sure to dispose of the ribbon cassette properly (see also the chapter on
recycling).
Before inserting the cassette into the printer housing, tighten the ribbon by
turning the knob on the cassette clockwise.
Grip the cassette on the handle bar and insert it in a way that the guiding
pins beside the cassette will slide into the recesses of the ribbon housing.
Make sure that the ribbon will be threaded between the guiding pins and
the print head.
Tighten the ribbon again by turning the knob several times. Close the flap.
Pull the receipt paper to front and close the housing cover.
18