Transcript
AEVR SAFETY PRECAUTION This manual uses the following symbols to ensure safe operation of this product. MULTI-FUNCTIONABLE DIGITAL VOLTAGE CONTROLLER User's Manual Warnings are indicated when mishandling this product might result in death or serious injury to user. Cautions are indicated when mishandling this product might result in minor injury to the user, or only physical damage to the timer. WARNING CAUTION WARNING RESTRICTIONS ON USE ΘNote this incorrect wiring of this product can damage it and lead to other hazards. Make sure the product has been correctly wired before turning the power ON. ΘBefore wiring, or removing / mounting the product, be sure to turn the power OFF. Failure to do so might cause electric shock. ΘDo not touch electrically charged parts such as the power terminals. Doing so might cause electric shock. ΘDo not disassemble the product. Doing so might cause electric shock or faulty operation. When using this product in applications that require particular safety or when using this product in important facilities, please pay attention to the safety of the overall system and equipment. Install failsafe mechanisms, perform redundancy checks and periodic inspections and adopt other appropriate safety measures when it is necessary. CAUTION ΘUse the product within the operating ranges recommended in the specification (temperature, humidity, voltage, shock, mounting direction, atmosphere and etc.). Failure to do so might cause fire or faulty operation. ΘMake sure the product is firmly connected to the socket. Failure to do so might cause electric shock or fire. SPECIFICATIONS NAMES AND FUNCTIONS OF FACEPLATE Voltage indicatior Display Operating voltage AC/DC : 100 ~ 240V Allowable operating voltage range 85 ~ 110% of rated operating voltage Rated frequency 50 / 60 Hz Time indicatior in second Phase sequence R S T Contact rating 250VAC 5A (Resistive load) Display Display resolution ²1% Power consumption Approx. 3.3VA Life Mechanical : 5,000,000 times / Electrical : 100,000 times Ambient temperature -10 ~ +50 °C Ambient humidity MAX 85% RH Weight Approx. 135g Under voltage setting V S ANLY Over voltage tripping delay TYPE AEVR OVER UNDER VOLT VOLT Over voltage setting OVER UNDER TIME TIME UNBAL. REV. Setting values display 5S 1S OFF TEST Under voltage tripping delay AUTO Manual reset RESET Function settings SETTING PROCEDURE 1. Over voltage Setting R S T 3. Over voltage tripping delay setting R S T V OVER VOLT S UNBAL. REV. OVER TIME S Set the tripping delay for over voltage. The display will show existing 3-phase voltages after 10 seconds. Set the desired value for over voltage. The display will show existing 3-phase voltages after 10 seconds. 2. Under voltage Setting 4. Under voltage tripping delay setting 6. Setting values display 5. The function of DIP switches V By pressing "TEST" button, all setting value will be shown ordinally as follows. The display will show existing 3-phase voltages after 10 seconds. AUTO 5S 1S OFF ON Reverse phase protected REV. OFF Reverse phase unprotected ON Unbalance protected R S T R S T V UNDER VOLT S UNBAL. V UNDER TIME S Set the tripping delay for under voltage. The display will show existing 3-phase voltages after 10 seconds. Set the desired value for under voltage. The display will show existing 3-phase voltages after 10 seconds. ON Auto reset delay 5 sec 5S/1S R S T V R S T V R S T V R S T V S S UNDER VOLTAGE SETTING VALUE OVER VOLTAGE DELAY S UNDER VOLTAGE DELAY OFF Auto reset delay 1 sec TIMING CHART R S T R S T V S Reverse Time Phase-loss Time Reset Time Over Time Under Time Reset Time Unbalance Time V S R S T SR T R S LINE V V OVER VOLTAGE SETTING VALUE 2. Fault indications The existing 3-phase voltages will be shown ordinally every 3 seconds as follows. R S T R S T S OFF Manual reset DISPLAY 1. 3-phase voltages display V OFF Unbalance unprotected ON Auto reset AUTO R S T Over Voltage Normal >+ - 5% Under Voltage S R S T V R S T V S R S T V R S T V Phase Loss S N.O. ( 1-3 ) S S S N.C. ( 1-4 ) S CONNECTION 3-Phase 3-Wire 3-Phase 4-Wire MOTOR 1-Phase 2-Wire DC Voltage 1C MG.SW Bottom View LINE R S T M 4 MG.SW MOTOR Bottom View M 5 6 3 2 7 1 8 4 5 1 8 2b LINE LINE R S T N AC ~ ~ 4 5 1 8 3 2 LINE LINE ~ ~ DC AC 6 3 7 2 4 5 1 8 6 3 7 2 4 5 1 8 6 7 6 3 2 7 SOURCE SOURCE SOURCE AC/DC 100~240V AC/DC 100~240V AC/DC 100~240V SOURCE AC/DC 100~240V ANLY ELECTRONICS CO., LTD. http://www.anly.com.tw M-AEVR-D-B Printed in Taiwan