Download Network Data Loss Prevention 9.3.0 Product Guide - Rev E

10
Policies and rules
Managing rules
View rule parameters
View rule parameters by opening the policy the rule is filed under, then opening the rule.
Task
1
Select one of these options:
•
In ePolicy Orchestrator, select Menu | Data Loss Prevention | DLP Policies | Policies.
•
On your McAfee DLP appliance, select Policies | Policies.
2
Click a Policy Name to open the Edit Policy page.
3
Click a Rule name to open the Edit Rule page.
4
Open the categories under the Define, Actions, and Exceptions tabs.
5
If no changes are warranted, click Cancel.
Copy rules to policies
Rules can be copied from one policy to another.
Task
1
Select one of these options:
•
In ePolicy Orchestrator, select Menu | Data Loss Prevention | DLP Policies.
•
On your McAfee DLP appliance, select Policies.
2
Click a Policy Name to open the Edit Policy page.
3
Click a Rule name to open a rule.
4
In the Rule Name field, enter a new name.
If a similar name is needed, add a single character or space to distinguish it from the original.
5
(Optional) Type in a new description.
6
Assign the rule to a different policy by selecting one from the Policy menu.
The new rule will be stored in the selected policy.
7
Select a Severity to rate the importance of the rule.
8
Set the Inherit Policy State to Enabled.
If the rule is to be tuned, leave it in Disabled state so it can be run independent of its policy until it
reports the needed results reliably.
9
Make any needed changes to the parameters of the rule.
10 Click Save.
11 Open the policy containing the new rule to verify that it has been copied over.
98
McAfee Data Loss Prevention 9.3.0
Product Guide