Download user manual

Setup information
Battery status
DANGER! Do not try to set up the Trainer 101 until you have read and
observed all the precautions listed in “Safety information” on page 3.
•LED flashes slowly: battery capacity 15 - 100%, machine fully operational.
The yellow LED (4) on the top of the Trainer 101 indicates the state of
charge of the battery:
•LED flashes fast: battery capacity below 15%. Charge or change battery.
•LED lights permanently: battery flat or vaporizer damaged.
Unpacking
•LED does not light although battery is connected: machine in sleep mode.
The Trainer 101 is supplied with a battery pack (11) and smart battery charger.
Sleep mode
The Trainer 101 is supplied with the smoke fluid container empty to avoid
spillage during shipment. The container must be filled before using for
the first time.
Handling and installation
The Trainer 101 may be either hand-held by an operator or placed on a
surface in a static installation. If placing on a surface, ensure that the
machine is secure and that the surface can safely hold the weight of the
machine.
The fluid suction tube in the bottom of the fluid container must be immersed in smoke fluid during operation. Provided that this requirement
is respected, the machine may be oriented as follows:
•During hand-held use, the machine may be temporarily held at any angle.
•In static installations, the machine may be permanently installed at any
angle up to 30° from horizontal.
Provide a minimum clearance of 10 cm (4 inches) around the machine
and ensure free and unobstructed air flow to and around the machine.
Keep the smoke machine at least 60 cm (24 inches) away from
combustible and heat-sensitive materials.
Do not point output directly at a person’s face or at face height.
If smoke output is not activated for approximately 40 seconds, the Trainer 101 enters sleep mode in order to preserve battery charge. The Trainer
101 can remain In sleep mode for approximately 250 hours with a fully
charged battery.
The Trainer 101 returns from sleep mode to operational mode as soon as
the machine is fired by a press on the start button.
Checking fluid level
Important! Check the fluid level regularly and fill as necessary.
Repeatedly attempting to operate the machine without fluid may
cause damage that is not covered by the product warranty.
Check the fluid level in the translucent fluid container (9) regularly. Refill
with smoke fluid as soon as there is a risk that the end of the suction
tube in the bottom of the fluid container may not be completely immersed in smoke fluid.
If the fluid level is too low, fluid flow to the vaporizer will be insufficient,
and a safety cutout will cut power to the vaporizer. The cutout protects
the vaporizer under normal conditions, but repeatedly trying to operate
the machine with insufficient fluid will eventually cause damage that is
not covered by the product warranty.
If no smoke is produced when the start button is pressed, stop using the
machine immediately and check the fluid level.
Do not expose the machine to vibration.
Trainer 101 user manual
Operation
15