Download ADE-MAK
Transcript
8.8. Test Mode z Display characters received by serial port To enter test mode, press and hold the setup switch. After about three seconds, the test mode display automatically shifts to the first test menu function, A/DTST. Figure 8-3 shows the Test Menu structure. Note that, because the Test Menu functions are all on a single menu level, Press the key to execution the function. Press the key to exit test mode. Table 8-5 summarizes the test menu functions. In addition to normal and setup modes, test mode provides a number of diagnostic functions for the ADE-MAK, including: z Display raw A/D count z LCD test z Digital input and output monitor z Battery voltage monitor z Batter charging current monitor z Display digital filter raw counts z Reset configuration parameters to default values z Transmit test character (“U”) from serial port A/DTST TLCD IO BATV FILTR3 BATC DEFLT XMT U ECHO R Figure 8-3. Test Menu TEST Menu Function Description Display raw count from A/D converter. A/DTST Lit on all LCD segment for test LCD. TLCD Display digital input (Remote Switch) and output (Set Point) status IO 00000 RSW3 RSW2 RSW1 OUT1 OUT2 BATV BATC FILTR3 Display battery voltage in V Display battery charging current in A Display filtered raw count for digital filters 3 DEFLT Default parameters Press setup switch and Enter key at the same time to reset configuration and calibration parameters to factory default values. Load cells must be recalibrated before using the indicator (see Section 5.1.3. ). Transmit “U” Press and hold Enter key to send ASCII “U” characters (decimal 85) from the serial port. Echo received characters When Ready is displayed, press the Enter key to view characters received at serial port. The first two digits show the order of the character received (see diagram). XMT U ECHO R Table 8-5. Test Menu Function 51