Download Smart 2 (H264 models)
Transcript
Quality & Value The SmartDVR.com 4 Move mouse over programme. 5 Press icon and using wheel select preset number you wish to icon to save preset – “SET PRESET”will flash momentarily confirming save. Calling PTZ presets using mouse 1 Move mouse over 2 Press 3 Press icon and using wheel change the top left hand menu bar to button on mouse menu to select Preset number to call selected preset Operating PTZ via remote control The supplied remote offers limited PTZ functionality. The curser key will offer pan and tilt control however the calling of presets is not possible. The PTZ menu can be scrolled using the [+] key and selecting using [OK]. It should be noted that the DVR offers basic PTZ functionality over a number of protocols. However if complete control is required then a PTZ Keypad, appropriate to the camera being used, should be employed. Calling Dome Tours etc. will depend on the preset code allocated to the specific dome eg. PTZ300 = 51preset. Refer to cameras manual for further guidance. 4) SPOT MONITOR SETUP 1) SWITCHING INTERVAL Channel switching time (1 sec. ~ 99 secs.) 2) ALARM POP-UP Set ON to show screen pop-up on Alarm 3) MOTION POP-UP Set ON to show screen pop-up on Motion 4) EVENT POP-UP DURATION Set DURATION time of Alarm or Motion Event (1 sec ~ 99 secs.) If events (MOTION or ALARM) happen on several channel at the same time, channel No. 1 has the first priority to pop up. For example, if events happen on channel No. 1, channel No. 2 and channel No. 4 at the same time, channel No. 1 pops up. If the motion disappears on channel No. 1, then channel No. 2 pops up for the duration that you set. However, even though motion happens on channel No. 1again within the duration, channel No. 2 still displays. If motion on channel No.1 keeps on going even after the duration, channel No. 1 pops up again. 5) AUDIO SETUP Use direction button to move to channel and press [ENTER] button to set (ON/OFF). 40