Download CAAPE User`s Manual

Simulator Reference
CYC
Execute the application logic of the current application for the specified number of cycles
or amount of time. If tracing or monitors are set, the affected equations are displayed as
they execute. See SIM for execution of single statements; see RUN for running all
applications at once.
Formats:
CYC (execute the logic one full cycle from the current starting point)
CYC END (execute the logic until the end of the logic has been reached)
CYC NOCHG (execute the logic until no equation results have changed for a full
cycle or until MAX time has elapsed)
CYC num-cycles (execute the logic the specified number of cycles from the current starting point)
CYC mm MINUTES, ss SECONDS (execute the logic for the specified time
period)
where
num-cycles is the number of full logic cycles to run. A cycle is one full pass
through the logic, from the current starting point and back again.
mm and ss are the minutes and seconds to run the logic. This period is in simulation time, not necessarily real time as perceived by the user.
Examples:
CYC
CYC NOCHG
CYC 10
CYC 2 MINUTES, 5 SECONDS
DEL
See ADD.
P2512A, Rev. J, Aug/15
13-37
Alstom Signaling Inc.