Download 1300 InSpector 2000 Hardware Manual

Initial Setup
The high voltage range and polarity can be verified by physically viewing the high voltage module installation. Again, please reference Appendix E, Configuring the High Voltage Power Supply for instruction on verifying and changing the InSpector 2000’s high
voltage range and polarity. If the InSpector 2000 is already operational with the computer
and Genie-2000 software the high voltage configuration and settings can be verified
reviewing the MCA Front-End Hardware Status report in the Gamma Acquisition and
Analysis application. The Status report can be opened by clicking on MCA and then Status in the drop down menu. If the MID definition and the high voltage power supply con figuration do not match Genie-2000 will report a hardware verification error when
attempting to open the data source. For complete information on the MID Files and the
Gamma Acquisition Analysis application, please refer to the Genie-2000 Operations
manual.
It is recommended that the high voltage setting be verified prior to turning the high voltage power supply to ON.
CAUTION
Excessive voltage and/or incorrect polarity can permanently
damage the detector system.
Power Connections
Power Sources
The InSpector 2000 can operate by using either a lithium-ion battery or an ac adapter.
Refer to Appendix D, Power System for more information.
Charging the Battery
Before the Lithium-ion battery shipped with the InSpector 2000 can be used, it must be
charged with the supplied battery charger.
To charge a battery, if installed remove it from the InSpector 2000 (see “Battery Removal” on page 15), attach it to the charger and plug the charger into a line power outlet.
The charger’s orange Charge lamp will stay on while the battery is being charged. When
the lamp goes out, the battery is fully charged. Refer to the charger’s user manual for
complete instructions.
When using the ac or car battery adapters a trickle charger built into the InSpector 2000
will charge the installed battery. The trickle charging time is dependent on the preamp
power loading. For more information please refer to Appendix D, Power System.
Note:
The power switch must be in the ON (”1”) position for the trickle charger to
charge the battery.
13