Download TMO2D-TC Operating Manual 4 MB

11/1/95
Wiring the TMO2-TC
Transmitter (cont.)
Wiring connections to the TMO2-TC Transmitter are made to
terminal block TB1, which is accessed by removing the TMO2-TC
cover. See Figure 2-5 below for the location and pin designations for
TB1. Also refer to Appendix C, Outline and Installation Drawings.
1
2
3
4
Red
Blk
Wht
+24 VDC/1Amp 1
Return 2
Output Signal 3
No Connection 4
Figure 2-5: TMO2-TC Wiring Connections
Wiring connections to the TMO2D-TC Display are made to the
terminal block labeled OXYGEN CELL at the rear of the TMO2DTC. See Figure 2-6 on the following page for the location of the
OXYGEN CELL terminal block.
Caution!
Do not make any connections to unassigned or unused
terminals.
2-8
Installation