Download 7065 - ALL ACTIVE SOLUTIONS September 2007

7065
The Program Job application does not change Copy Mode while the job is being output, even though the Copy Mode was changed when the original sets
were scanned.
Solution
This has been identified as a product limitation by Konica Corporation. If this is unacceptable, please contact the product manager at
[email protected].
Solution ID
TAUS0611540EN*
Solution Usage
5
Description
FS108B, E70-0 at power up.
Solution
CAUSE: A communication error between the finisher CB and main CB has occurred.
SOLUTION: Check the paper exit cover open/close detection PS207 (p/n 540085510). Refer to FS108BM/PI108 parts catalog, 1st Edition, October 1999,
page 7, item 5. Verify connector at PS207 and finisher CB at connector 1 pin(s) A13, A22 and B18.
Solution ID
TAUS0611726EN*
Solution Usage
5
Solution Usage
5
Solution Usage
5
Solution Usage
5
Description
PLEASE LOAD SIZE 8.5x14 PAPER message.
Solution
CAUSE: APS is disabled in the Key Operator Mode Memory switches, for Tray 2.
SOLUTION: To enable APS for Tray 2, perform the following:
1. Access the Key Operator Mode (hold down the Help button at power up).
2. Select [9: Memory Switch].
3. Use the up arrow button and scroll to No.10: ATS/APS switch (Tray 2).
4. Press the Change Setting Content button and set switch No.10 to [ON].
5. Power copier OFF/ON to return back to normal copy mode.
Solution ID
TAUS0611834EN*
Description
FS108B, when printing, cannot fold and/or staple.
Solution
Upgrade to the latest version EPROM's available on our TechWeb.
Solution ID
TAUS0611878EN*
Description
DF312, does not recognize 8.5x14 folded originals.
Solution
CAUSE: The original size detection sensor1 (PS303) is not actuated.
SOLUTION: To enable Z-folded originals, perform the following:
1. Press the SPECIAL ORIGINAL button.
2. Press Z-FOLDED ORIGINAL on the touch screen.
3. Select any additional options as needed.
4. Press OK.
5. Insert the Z-folded and normal originals into the document feeder.
6. Press START PRINT button.
Solution ID
TAUS0613467EN*
Description
How to program ATS (auto tray switching), 7065.
Solution
To program the ATS, perform the following:
1. Access the key operator mode (press and hold the help key while turning the machine ON).
2. Select #9: Memory switches.
Copyright 2007, Konica Minolta Business Solutions U.S.A., Inc.
September 2007
27