Download Manual - Roth Audio
Transcript
User Manual English Connections & Settings 1. Connecting to your TV’s Digital Toslink Audio Soundbar remote then connect your Soundbar’s 12 Volt Output: If your TV has an optical digital audio output power supply to live wall power and to the input power (usually located on the rear connection panel), use the jack on the rear of the Sound bar. Using the Input & included optical cable to connect your TV’s digital audio Vol+ buttons on the front of the Soundbar select the output to the digital audio input on the rear of the Aux1 input and turn the Volume up to -40. For this Soundbar. Check the Audio Settings section in your TVs connection type you may simply continue to use your Menu System and ensure that the digital output audio TV remote to control the volume and do not need to type is set to PCM. Skip to Point number 4. use the soundbar remote except to access its specialized Connecting your TV’s Headphone Output: If your functions. Please skip to Point number 5. 4) To prevent TV has a headphone output jack (usually located on the the TV’s speakers from interfering with the Soundbar’s front or side), use the 1/8” to 1/8” connection cable to output, please find the Audio Settings section in your TV’s connect your TV’s headphone output jack to the Aux1 Menu System and turn off the TV’s internal speakers. If input on the rear of the Soundbar. In most cases, use of you are unable to turn off your TV’s speakers please try the headphone jack should automatically turn off your using the headphone output instead. If no headphone TV’s internal speakers. If after connecting the cable to output is available then simply turn the TV volume all your TV’s headphone jack your TV speakers remain on the way down. Install the included batteries into your skip to Point number 2, otherwise skip to Point number 3. Soundbar remote then connect your Soundbar’s 12 Volt Connecting to your TV’s RCA Outputs: If your TV power supply to live wall power and to the input power does not have a headphone output jack or you would prefer to connect your Soundbar to your TV’s RCA audio outputs (usually located on the rear connection panel), use the included Stereo RCA to 1/8” connection cable to connect your TV’s RCA audio outputs to the Aux1 input on the rear of the Soundbar. Note: TV RCA audio outputs jack on the rear of the Sound bar. Using the Input & Vol+ buttons on the front of the Sound bar select the input you connected your TV to (Digital or Aux1) and turn the Volume up to a satisfactory level. To control the Soundbar’s volume with this connection type you must use the Soundbar remote. are either Variable (output level changes with TV volume 5.Connecting Audio Only Sources: For the easiest system setting) or Fixed (output level does not change with TV setup, video sources (Bluray, DVD, VHS, Cable/Satellite volume setting). Some TV’s RCA outputs can be set to receivers, Video Games, etc.) should be connected directly be Fixed or Variable in the Audio Settings section of your to your TV and the Soundbar directly to your TV’s audio TV’s Menu System. Please use the Variable outputs if outputs as described above. If you have additional audio available. If your TV only has Fixed RCA outputs please only sources (portable music players, computers, etc.) you skip to Point number 4. may connect them to one of the other inputs on the rear 2.To prevent the TV’s speakers from interfering with the of the Soundbar. Soundbar’s output, please find the Audio Settings section 6.Connecting Through Bluetooth: Press the input button in your TV’s Menu System and turn off the TV’s internal on the remote control until the input displays Bluetooth speakers. They must be turned ‘off, the TV volume cannot on the front panel of the soundbar. Search for the just be turned down as this would result in no output on soundbar with your Bluetooth device and select / Pair. the headphone or RCA jacks for the Soundbar! If you are unable to turn off your TV’s speakers and are connected to its RCA outputs please try using the headphone output instead. 3) Install the included batteries into your Continued... rothaudio.co.uk | 5