Download Model 42i-HL - User Manual

C-Link Protocol Commands
Measurement Configuration
Table B-6. Operating Ranges, continued
Selection
ppm
mg/m3
8
5,000
7,500
9
C1
C1
10
C2
C2
11
C3
C3
custom range
range = | 1 | 2 | 3 |
This command reports the user-defined value of custom range 1, 2, or 3.
The example below reports that custom range 1 is defined to 55.0 ppm.
Send:
Receive:
custom 1
custom 1 5500E-2 ppm
set custom range value
set custom 1 value
set custom 2 value
set custom 3 value
set custom 1 range value
set custom 2 range value
set custom 3 range value
These commands are used to set the maximum concentration for any of the
three custom ranges 1, 2, or 3 to range value, where value is a floating-point
number representing concentration in ppm or mg/m3. The example below
sets the custom 1 range to 55.5 ppm.
Send:
Receive:
set custom 1 range 55.5
set custom 1 range 55.5 ok
range mode
This command reports the current range mode.
Send:
Receive:
range mode
range mode single
set range mode mode
This command sets the current range mode to single, dual, or auto. The
example below sets the range mode to single.
Send:
Receive:
B-30
Model 42i High Level Instruction Manual
set range mode single
set range mode single ok
Thermo Fisher Scientific