Download Software Operation

NEXT FILE
This key is valid under Multiple file mode only. Press this key the LCD shows
File: # x
Speed: xx
Power: xx
DPI: xxx
file name
%
00:00
% PPI: xxxx
xxxxx k
The “k” message shows on the lower right corner expresses the k bytes memory that
has been left over in the buffer.
File: # shows the current working file number. Press NEXT FILE each time will
increase 1 (i.e. 1, 2, 3…100) and recycle the counting. Once the buffer has received
up to 100 files, the LCD shows:
More than 100 files
are not allowed
Please delete some
and send again
If a file received is out of memory, the LCD shows
Not a complete file
due to out of memory
Please delete some
and send again
RED BEAM
On/Off red beam
SPEED
Set up laser speed for desired effect. When working without using JUPITER’s driver.
Press FUNCTION key then select one of the sixteen setups then set up desired
cutting speed. No matter you are using JUPITER’s driver or not, you can press
PAUSE key prior to change speed during cutting or engraving. Set up desired speed,
press ENTER then press RESUME to start the job again.
POWER
Set up laser power for desired depth and effect. Other conditions are same as stated in
SPEED.
PAUSE
Temporarily stop the job during cutting or engraving.
18