Download Agilent N9360A W-CDMA Programming Manual

Programming Command Summary
6
Configuration : Test Condition (Loss) Screen
The following command is used to set the controls and
parameters associated with the [Configuration : Test Condition
(Loss)] screen.
Table 6-8 CONDition (Loss) Command Summary
Item
Command
Attenuation Control
CONF:LOSS ON|OFF|1|0
CONF:LOSS?
CONF:LOSS:RFIN <<
<real 1>,<real 2>,<real 3>,<real 4>,<real 5>,<real
6>,<real 7>,<real 8>,<real 9>
CONF:LOSS:RFIN?
CONF:LOSS:RFOU <<
<real 1>,<real 2>,<real 3>,<real 4>,<real 5>,<real
6>,<real 7>,<real 8>,<real 9>
CONF:LOSS:RFOU?
Configuration: Test Condition (Limit) Screen
The following commands are used to set the controls and
parameters associated with the [Configuration: Test Condition
(Limit)] screen.
Table 6-9 CONDition (Limit) Command Summary
Item
Command
Open Loop TX Power
CONF:COND:LIM:OPEN <real LO>,<real HI>
CONF:COND:LIM:OPEN?
Inner Loop Power (Down Min)
CONF:COND:LIM:INNE:DMIN <real LO>,<real HI>
CONF:COND:LIM:INNE:DMIN
Inner Loop Power (Down Max)
CONF:COND:LIM:INNE:DMAX <real LO>,<real HI>
CONF:COND:LIM:INNE:DMAX?
Inner Loop Power (Up Min)
CONF:COND:LIM:INNE:UMIN <real LO>,<real HI>
CONF:COND:LIM:INNE:UMIN?
Inner Loop Power (Up Max)
CONF:COND:LIM:INNE:UMAX <real LO>,<real HI>
CONF:COND:LIM:INNE:UMAX
N9360A Multi UE Tester W-CDMA Programming Manual
6-13