Download manual - WorldSpace Foundation

If your system had only one serial port, select COM1. If you have more than one, select
the one into which that you inserted your serial cable. Note that if your computer labels
the port A, B, etc., port A corresponds to COM1, port B corresponds to COM2, etc. As
for the baud rate, you should leave it at 115,2000. After you make your selections, click
on Save. The system will prompt you to shut down the Client Services program to let the
changes take effect, click on Yes.
Note: this screen can be accessed at any time by running the WorldSpace
Client Services program, double-clicking on its PC and satellite dish icon
in the system tray (next to the clock on the lower right of the PC screen,
and then selecting “COM Port” under the “Configure” pulldown menu.
Starting the Program from the Desktop
After having configured the WorldSpace Client Services program, you will need to start
it again for the next part of the tutorial. To do so, let’s use the desktop icon, as shown
below.
Downloading Content with the WorldSpace Client Services Program
Note: please disable any screen savers during download. This is because
the operating system allows the screen saver to use all the CPU resources
during portions of its operation. When this happens, the WorldSpace
Client Services Program cannot download content properly . The result
will be errors in the transmission. To avoid these errors, simply turn off
the screen saver during download.
13