Download FLEXWIN User`s Manual - Computational Infrastructure for

Transcript
CHAPTER 3. TUNING FLEXWIN FOR YOUR SEISMOGRAMS
13
CC BASE Corresponds to CC0 in Table 3.1, and is the minimum normalized cross-correlation
value between synthetic and observed seismogram for a window to be acceptable.
TSHIFT BASE Corresponds to ∆τ0 in Table 3.1, and is the maximum cross-correlation lag (in
seconds) between synthetic and observed seismogram for a window to be acceptable.
DLNA BASE Corresponds to ∆ ln A0 in Table 3.1, and is the maximum amplitude ratio (∆ ln A
or ∆A/A) between synthetic and observed seismogram for a window to be acceptable.
TSHIFT REFERENCE Corresponds to ∆τref in Table 3.1, and allows for a systematic traveltime
bias in the synthetics.
DLNA REFERENCE Corresponds to ∆ ln Aref in Table 3.1, and allows for a systematic amplitude
bias in the synthetics.
C 0 Corresponds to C0 in Table 3.1, and is expressed as a multiple of wE . No window may
contain a local minimum in its STA:LTA waveform that falls below the local value of
C0 wE . See Figure 3.1b.
C 1 Corresponds to C1 in Table 3.1, and is expressed as a multiple of T0 . No window may be
shorter than C1 T0 .
C 2 Corresponds to C2 in Table 3.1, and is expressed as a multiple of wE . A window whose
seed maximum on the STA:LTA waveform rises less than C2 wE above either of its
adjacent minima is rejected. See Figure 3.1c.
C 3a Corresponds to C3a in Table 3.1, and is expressed as a fraction. It regulates the acceptable height ratio between local maxima in a given window on the STA:LTA waveform.
See Figure 3.2.
C 3b Corresponds to C3b in Table 3.1, and is expressed as a multiple of T0 . It regulates the
acceptable time separation between local maxima in a given window on the STA:LTA
waveform. See Figure 3.2.
C 4a Corresponds to C4a in Table 3.1, and is expressed as a multiple of T0 . It limits the
length of a window before its first local maximum in STA:LTA.
C 4b Corresponds to C4b in Table 3.1, and is expressed as a multiple of T0 . It limits the
length of a window beyond its last local maximum in STA:LTA. See Figure 3.1d.
WEIGHT AVERAGE CC Corresponds to wCC in Table 3.1, and is the weight given to the average
cross-correlation value in the process of resolving window overlaps. See Figure 3.3.
WEIGHT SPACE COVERAGE Corresponds to wlen in Table 3.1, and is the weight given to the
time span covered by windows in the process of resolving window overlaps.