Download FLEXWIN User`s Manual - Computational Infrastructure for

Transcript
CHAPTER 3. TUNING FLEXWIN FOR YOUR SEISMOGRAMS
18
STALTA_W_LEVEL(i)=STALTA_BASE
S2N_LIMIT(i)=WINDOW_AMP_BASE
enddo
It is then up to the user to modulate these values for the specific problem at hand. For example, should the user want to discourage the algorithm from picking windows beyond the end of
the first surface wave-train R1, the following lines should be added to the user functions.f90
file to raise the water level on the STA:LTA waveform by a factor of ten:
! -------------------------------! Set approximate end of rayleigh wave arrival
R_vel=3.2
R_time=dist_km/R_vel
! -------------------------------! modulate criteria in time
do i = 1, npts
time=b+(i-1)*dt
if (time.gt.R_time) then
STALTA_W_LEVEL(i)=STALTA_BASE*10.0
endif
enddo
Should the user want the algorithm to be less stringent in its requirements for the crosscorrelation fit for the surface wave portion of the seismograms, and allow a greater travel-time
lag for deeper events, the required lines could be:
! -------------------------------! Set approximate end of rayleigh wave arrival
R_vel=3.2
R_time=dist_km/R_vel
! -------------------------------! Set approximate start of love wave arrival
Q_vel=4.2
Q_time=dist_km/Q_vel
! -------------------------------! modulate criteria in time
do i = 1, npts
time=b+(i-1)*dt
! if we are in the surface wave times, then make the cross-correlation
! criterion less severe
if (time.gt.Q_time .and. time.lt.R_time) then