Download xNAV User Manual

Transcript
Figure 10. NAVconfig Primary Antenna page
Secondary antenna position
The Secondary Antenna page, shown in Figure 11, is used to define the position of the
GNSS antenna connected to the secondary receiver, relative to the primary one. The
secondary antenna should be placed in accordance with the information given in the
installation section on page 17.
Ensure to click the Enable secondary antenna checkbox to allow the configuration to
be entered. If it is not enabled, the xNAV will ignore the secondary antenna and will not
use it to compute a heading solution.
By default the Antennas are level box is checked. This means the antenna baseline
should be within 15° of horizontal. When the antennas are level the separation should be
measured to within 5 cm. If the antennas are not level, i.e. mounted with height offsets
or on an incline, then the box should be unchecked. In this case, the separation should be
measured to within 5 mm.
Enter the antenna separation and select the position of the secondary antenna relative to
the primary antenna from the drop-down list. The measurement accuracy can also be
24
Oxford Technical Solutions