Download Manual - MattairTech

Transcript
MT-DB-U2
Manual
dfu­programmer
dfu­programmer is a command line utility used to program the ATmega32U2 that runs under Linux. A DFU driver installation is not required. Download version 0.5.4 or higher from http://dfu­
programmer.sourceforge.net/ . The following commands can be used:
dfu­programmer atmega32u2 erase
dfu­programmer atmega32u2 flash­eeprom YourHex.eep (if applicable)
dfu­programmer atmega32u2 flash YourHex.hex
dfu­programmer atmega32u2 start (to jump to application section without reset)
October 29, 2015
23
http://www.mattairtech.com/